Click to enlarge

ES W1 C1

Tile Adhesive C1 (White)

The ES W1 adhesive is used for laying ceramic tiles of high absorbency, mainly on indoor floor surfaces. It can be applied on conventional substrates from normal and lightweight concrete, cementitious renders, etc. Homogeneous, ready to mix, industrial product of consistently high quality. It ensures good workability, increased application speed, it is economical and provides excellent results.

Σύσταση & Χαρακτηριστικά

• Mixture of white cement of high specifications and crushed marble of strictly selected granulometry and quality, enriched with special improving additives. • It complies with EN 12004-1 and is classified as C1 adhesive for internal use.

Εφαρμογή

• The substrate must be clean and firm and it is recommended that it is wetted before application. • The contents of the bag shall be gradually added to clean water (approximately 4.5-5.0 l/bag) under continuous stirring using an electric mixer at low speed until a homogeneous mixture is obtained. The mixture is allowed to cure for 5 minutes and then stirred again before the application. • The adhesive should be applied (“combing”) with a serrated putty knife (6-10 mm). The tiles must be placed and pressed to come to the desired position within 20 minutes. The limits of the application time of the prepared adhesive are such that they allow for any correction necessary to fix the tiles in their exact final position. • If the substrate has been covered with a render, its moisture content must be less than 2.5% before the adhesive is applied. • During the application of the adhesive, and for a few hours afterwards, extreme climatic conditions (such as strong wind, rain, dust, direct sunlight, etc.) should be avoided and the temperature should be between +5 °C and +35 °C. • Grouting of floors can be carried out after 24 hours.

Συσκευασία & Φύλαξη

• In bags of 20 kg, on pallets. In plastic bags of 5 kg, in cartons. • In a dry place where frost does not form, for 12 months from the date of production, in unopened bags.

Κατανάλωση

2.0-4.0 kg/m2, depending on the type and size of the tiles and the substrate.

Τεχνικά Χαρακτηριστικά

Specifications: EN 12004-1

Granule size 0.0-0.7 mm
Open adhesion time 20 minutes
Apparent dry mortar density 1300 kg/m3
Adhesion at open adhesion time ≥0.8 N/mm²
Adhesion in dry conditions ≥1.6 N/mm2
Adhesion when immersed in water ≥1.1 N/mm2
Adhesion under heating conditions ≥1.1 N/mm2
Adhesion under freezing-thawing conditions ≥1.0 N/mm2
Slip ≥0.3 mm
Grouting on floors 24 hours
Grouting on walls 8-10 hours
Consumption 2-4 kg/m2
Pot life 4 hours
Micro-adjustments time 30 minutes

The ES W1 adhesive contains cement which is classified as an irritant. Consult the safety instructions and precautions listed in the Material Safety Data Sheet of the product. Although the specifications and instructions presented in this bulletin have been prepared to the best of our skills, knowledge and experience, they should be taken as indicative results and require verification after many applications.  Users to whom this product is addressed should verify its suitability for the intended application.  The end user is responsible for any result of the use of the product.